CRI 1961. ✓ Resurrection fails when killed in combat (2017-07-16 21:17:00)
CRI 1305. ✓ Environmental temperatures will now be clamped at the range [223.15, 323.15] K; switched to K for internal temperature representation (APIs unaffected) (2017-05-04 00:16:39)
NEW 2820. Resurrection unable to toggle off (2023-02-15 07:25:57)
NEW 2818. Fukushu not detonating on death (2023-01-31 06:33:18)
NEW 2727. Loss of local chat (2022-01-21 22:04:08)
MAJ 2729. ✓ refuse attached weather stations (2022-01-30 16:37:29)
MAJ 2216. ✓ Water-cooled units bricked by fatal dehydration (2018-08-06 15:11:14)
MAJ 2192. ✓ Immediate overheat on power up (2018-10-12 11:33:25)
MAJ 2066. ✓ New attempt at fixing exploding battery bug (2017-12-28 00:44:06)
ENH 2556. Sending ATOS/A "killed" messages (2021-05-10 13:42:40)
ENH 2407. ✓ Incremental malfunction fixing for Arachne table (2019-11-17 10:38:27)
ENH 2281. ✓ Send CONDITION_XCVR on PROBE_MODULES_DONE (2019-02-08 18:09:10)
ENH 2280. ✓ Lowered malfunction chance to 2.5%, regardless of whether or not a cortex is installed (2019-01-19 21:40:00)
ENH 2234. ✓ Disabled damaged velocity-based collisions while seated. Hits from name-based projectiles will still be registered. (2018-11-17 11:47:27)
ENH 2113. ✓ Compatibility with 8.5a1 QUERY_UNIT_INFO format (2018-02-12 12:28:24)
ENH 2067. ✓ Clear some transceiver malfunctions when hit with a 'repair' message or projectile and at 100% integrity afterward (2018-01-15 10:45:42)
ENH 1992. ✓ Cortex and transceiver malfunctions (2017-10-04 06:28:06)
ENH 1936. ✓ Changed cooling model for fanless controllers to be 100% dependent on lubricant level (2017-07-02 12:22:10)
ENH 1923. ✓ Shield-based crash protection (2x for ready, 3x for active), increased base crash protection (2017-07-02 12:21:16)
ENH 1922. ✓ Pressure and pressure damage support (2017-06-18 19:42:47)
ENH 1903. ✓ TrueShield (2017-05-28 06:16:08)
ENH 1901. ✓ Heat from interference (2017-05-28 06:04:48)
ENH 1217. ✓ Added 'base-temp' CSU keyword (2017-03-07 18:07:44)
ENH 1216. ✓ Reduced clock speed to 2 Hz (was 4 Hz) (2017-03-07 18:07:48)
ENH 1215. ✓ Added temperature unit control for ° C, ° F, or K (defaults to Celsius; no HUD support yet) (2017-03-07 18:05:07)
ENH 691. ✓ Added 907 SENTINEL_INTEGRITY for applications, and modified 900 SENTINEL_STATUS to be able to send it (2017-01-22 08:51:31)
ENH 650. ✓ Halved impact damage when unit is moving and collider isn't (2017-01-08 02:35:50)
ENH 588. ✓ overheat-temp support from chassis config (2016-12-24 17:05:15)
ENH 575. ✓ Switch to using !broken/!fixed instead of direct light bus messages (2016-12-17 18:17:20)
MOD 2706. ✓ [AT_DMG] and meleedamage only dealing a tenth of correct amount (2021-12-14 15:34:26)
MOD 2607. ✓ Don't take controls in state_entry (2021-05-27 04:25:46)
MOD 1218. ✓ Out-of-bounds CSU settings are now ignored (previously a bad chassis durability modifier would cause boot problems and out-of-range temperatures were accepted) (2017-03-07 18:07:41)
MOD 703. ✓ Fixed spamming of 907 and integrity messages (again) (2017-01-26 19:11:50)
MOD 605. ✓ limit frequency of integrity light bus messages during self-repair (2016-12-31 17:25:08)
MIN 2609. ✓ Death animation fix (2021-05-30 19:42:11)
MIN 1964. ✓ Fixed cases where out-of-bounds pressure could be accepted when simultaneously encountering extreme temperature (2017-07-23 17:17:33)
MIN 649. ✓ Fixed some cases where fixed was being sent directly over the light bus (2017-01-08 02:35:53)
MIN 513. ✓ Remove power draw during module uninstall. Add a linked message to the eraser script, maybe? (2016-12-18 10:02:26)
MIN 365. ✓ '@optics apply' or equivalent linked message to fix gamma after overheating ends (2016-12-17 18:38:50)
TRI 2326. ✓ Reload damage folders only if RLV_DIR provides changed path (2019-04-08 18:30:54)
TRI 2044. ✓ Sentinel not turning off repair nanite particles after damage is repaired. (2018-03-23 01:30:40)
TRI 1985. ✓ Fixed measurement units for pump rate (2017-09-17 20:02:34)
TRI 1963. ✓ Fixed @sentinel ignoring chassis strength in displayed integrity numbers (2017-07-23 17:00:00)
REJ 2267. ✓ Setting base-temp causes constant overheating (2019-10-14 04:45:55)
Next
all